AMX HDMI-UTPRO-0808 Instruction Manual page 73

Master Connection Tab
Click the Master Connection tab in the Device Configuration page to view/edit the Master Connection for the
HDMI UTPro (FIG. 47).
FIG. 47
Device Configuration page (Master Connection tab)
Use the options on the Master Connection page to view/edit the Connection Mode, Mode Settings and Authentication
Settings for the HDMI UTPro's connection to the NetLinx Master.
Changing the Connection Mode
The available connection modes are indicated under Connection Mode (default = TCP/IP Auto). Click on the radio
buttons to select the different modes.
Note: The options under Mode Settings will change, depending on the Connection Mode selected.
Changing the Mode Settings
The supported Connection Modes and the available mode settings for each are described in the following table.
Connection Modes and Mode Settings Options
TCP/IP URL
TCP/IP Listen
TCP/IP Auto
UDP/IP URL
UDP/IP NDP


Authentication Settings
If the NetLinx Master requires authentication, enter the Master Username and Master Password in the applicable fields.
Instruction Manual – HDMI-UTPRO-0808
• Master IP/URL -
• Master Port Number - The default value is 1319, and should not be changed.
• Master Port Number - The default value is 1319, and should not be changed.
• System Number -
• Master Port Number - The default value is 1319, and should not be changed.
• Master IP/URL -
• Master Port Number - The default value is 1319, and should not be changed.
• Master IP -
• Master Port Number - The default value is 1319, and should not be changed.
Click Accept to save the changes. Changes on this page take effect immediately.
Click Cancel to exit the page without saving any changes.
HDMI UTPro WebConsole
73