Table 11 Bis Engine And Dsc Error Messages - GE Datex-Ohmeda S/5 Series Technical Reference Manual

Table 11 BIS Engine and DSC error messages
Message
Illegal message ID
Illegal command parameter
Illegal length for layer 2 data
Disabled interrupt received -
UART transmitter empty interrupt
Disabled interrupt received -
UART modem interrupt
No status nibble received
DSC not connected
DSC disconnected after test failure
Illegal DSC ID
DSC power regulation fault
DSC interface fault
DSC did not respond to command
Illegal PIC ID
DSC overcurrent
DSC overrun
EEPROM Bad packet length
EEPROM Bad checksum
EEPROM Bad code length
EEPROM Illegal packet subtype
EEPROM physical write error
EEPROM NOT_DATA_TIMEOUT
Errors of type 2
Errors for layer 3 packets
UART related errors
DSC related errors
Software update related
errors
Document no. M1144955-001
Service Menu
65