No Banner Command - Nortel 4500 Series Overview-System Configuration

"banner parameters" (page 111)
command.
banner parameters
Parameters and
variables
static | custom
line number
LINE
disabled
Run the banner command in Global Configuration command mode.

no banner command

The no banner command clears all lines of a previously stored custom
banner. This command sets the banner type to the default setting (STATIC).
The syntax for the no banner command is
no banner
Run the no banner command in Global Configuration command mode.
Banner tab
The Banner tab controls the CLI banner display.
To configure the Banner Control, perform the following procedure.
Step
1
2
Copyright © 2007, Nortel Networks
.
Description
Set the display banner as
•
•
Enter the banner line number you are setting. The
range is 1 to 19.
Specify the characters in the line number.
Disable the banner display.
Action
Open the Edit Chassis screen in the manner detailed at the
beginning of this section.
Select the Banner tab, as illustrated in
Banner tab" (page 112).
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
Customizing the CLI banner 111
describes the parameters for this
static
custom
" Edit Chassis screen --
Nortel Networks Confidential