Assigning And Clearing Ip Addresses - Nortel 4500 Series Overview-System Configuration

copy nvram config block command
This command copies the configuration stored in flash memory at the
specified location and makes it the active configuration. The syntax for
this command is
copy nvram config block
Substitute <1-2> with the configuration file to load.
This command resets the switch to reset so that the new configuration load.
Run this command in Global Configuration command mode.

Assigning and clearing IP addresses

Use the CLI, to assign, clear, and view IP addresses and gateway
addresses. For details, see the following sections:
•
•
•
•
•
ip address command
The ip address command sets the IP address and subnet mask for the
switch or a stack.
The syntax for the ip address command is
ip address [stack | switch | unit] <XXX.XXX.XXX.XXX> [netmask
<XXX.XXX.XXX.XXX>
Run the ip address command in Global Configuration command mode.
If the stack or switch parameter is not specified, the system automatically
modifies the stack IP address when in stack mode and modifies the switch
IP address when in stand-alone mode.
Copyright © 2007, Nortel Networks
.
General switch administration using the Command Line Interface 171
"ip address command" (page 171)
"no ip address command" (page 172)
"ip default-gateway command" (page 172)
"no ip default-gateway command" (page 173)
"show ip command" (page 173)
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
<1-2>
Nortel Networks Confidential