Table of Contents
Advertisement
Backup configuration
Follow the instructions as shown in Menu 24.5
Figure 82 Menu 24.5 - System Maintenance - Backup Configuration
To transfer the configuration file to your workstation, follow the
procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your Business Secure Router. Then type
"nnadmin" and SMT password as requested.
3. Locate the 'rom-0' file.
4. Type 'get rom-0' to back up the current Business Secure Router
configuration to
your workstation.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your Business Secure Router
manual.
Using the FTP command from the command line
1
Launch the FTP client on your computer.
2
Enter open, followed by a space and the IP address of your Business Secure
Router.
3
Press [ENTER] when prompted for a username.
4
Enter your password as requested (the default password is PlsChgMe!).
5
Enter bin to set transfer mode to binary.
6
Use get to transfer files from the Business Secure Router to the computer, for
example, get rom-0 config.rom transfers the configuration file on the
Business Secure Router to your computer and renames it config.rom. See
earlier in this chapter for more information on filename conventions.
7
Enter quit to exit the ftp prompt.
Chapter 15 Firmware and configuration file maintenance 161
Menu 24.5 - System Maintenance - Backup Configuration
Press ENTER to Exit:
BCM50e Integrated Router Configuration - Advanced
(Figure
82).
Advertisement
Table of Contents
