Overview — System Configuration Nn47205-500 02.01 Standard 5.0 23 February - Nortel 4500 Series Overview-System Configuration

General Switch Administration using the Web-based Management Interface 201
IP page items
Item
Section
Boot Mode BootP
Setting Request
Mode
Copyright © 2007, Nortel Networks
.
IP page for a stack
Note: To change the IP information for a specific unit in the
stack, choose that unit and enter the desired IP information into
the In-Band Switch IP address field.
The following table "IP page items" (page 201)
on the IP screen.
Range
BootP When Needed
BootP Always
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
describes the items
Description
Choose this mode to inform the
switch to send a BootP request
when the switch IP address stored
in non volatile memory is the factory
default value. If the stored IP
address differs from the factory
default value, the switch uses the
stored network parameters. If the
switch cannot find a BootP server, it
tries five more times to find one and
then defaults to the factory settings.
Note: This is the default.
Choose this mode to inform the
switch, each time the switch boots,
to ignore stored network parameters
and send a BootP request. If the
BootP request fails, the switch
boots with the factory default IP
configuration. This setting disables
Nortel Networks Confidential