Set Port Power Enable Or Disable; Set Port Power Priority; Set Power Limit For Channels - Nortel 4500 Series Overview-System Configuration

Set port power enable or disable

Use the poe-shutdown command to disable PoE to a port.
The syntax for the poe-shutdown command is
poe poe-shutdown [port <portlist>]
Use the no poe-shutdown command to enable PoE to a port.
The syntax for the no poe-shutdown command is
no poe-shutdown [port <portlist>]
In either command, substitute <portlist> with the ports on which PoE is
enabled or disabled.
Run the poe-shutdown and no poe-shutdown commands in Interface
Configuration command mode.

Set port power priority

The poe-priority command sets the port power priority.
The syntax for the poe-priority command is
poe poe-priority [port
"poe-priority parameters" (page 159)
command.
poe-priority parameters
Parameter
port <portlist>
{low | high | critical}
Run the poe-priority command in Interface Configuration command
mode.

Set power limit for channels

The poe-limit command sets the power limit for channels.
The syntax for the poe-limit command is
poe poe-limit [port <portlist>] <3-16>
Copyright © 2007, Nortel Networks
.
<portlist>] {critical | high | low}
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
Configuring PoE using the CLI 159
outlines the parameters for this
Description
The ports to set priority for
The PoE priority for the port
Nortel Networks Confidential