Set Traps Control; Show Main Power Status; Set Power Usage Threshold - Nortel 4500 Series Overview-System Configuration

160 Power over Ethernet
"poe-limit parameters" (page 160)
poe-limit parameters
Parameter
port <portlist>
<3 - 16>
Run the poe-limit command in Interface Configuration command mode.

Set traps control

The poe-trap command enables PoE-related traps for PoE-enabled ports.
The syntax for the poe-trap command is
poe poe-trap [unit <1-8>]
Substitute <1-8> with the number of the unit on which to enable traps.

Show main power status

The show poe-main-configuration command displays the power
configuration.
The syntax for the show poe-main-configuration command is
show poe-main-status [unit
Substitute <1-8> with the number of the unit for which to display the
configuration.
Run the show poe-main-status command in Privileged EXEC
command mode.

Set power usage threshold

The poe-power-usage-threshold command sets the power usage
threshold in percentage on individual units.
The syntax for the poe-power-usage-threshold command is
poe poe-power-usage-threshold [unit <1-8>] <1-99>
Copyright © 2007, Nortel Networks
.
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
outlines the parameters for this command.
Description
The ports to set the limit on
The power range to limit at from 3 to 16 W
<1-8>]
Nortel Networks Confidential