Enabling Flow Control - Nortel 4500 Series Overview-System Configuration

180 Switch administration tasks
default autotopology command
The default autotopology command enables the Autotopology
protocol.
The syntax for the default autotopology command is
default autotopology
Run the default autotopology command in Global Configuration
command mode.
The default autotopology command has no parameters or values.
show autotopology settings command
The show autotopology settings command displays the global
autotopology settings.
The syntax for the show autotopology settings command is
show autotopology settings
Run the show autotopology settings command in Privileged EXEC
command mode.
The show autotopology settings command has no parameters or
values.
show autotoplogy nmm-table command
The show autotopology nmm-table displays the Autotopology network
management module (NMM) table.
The syntax for the show autotopology nmm-table command is
show autotopology nmm-table
Run the show autotopology nmm-table command in Privileged EXEC
command mode.
The show autotopology nmm-table command has no parameters or
values.
Enabling flow control
Gigabit Ethernet, when used with the Nortel Ethernet Routing Switch 4500
Series, can control traffic on this port using the flowcontrol command.
Copyright © 2007, Nortel Networks
.
Note: Due to Quality of Service (QoS) interaction, the Ethernet Routing
Switch 4500 cannot send pause-frames.
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
Nortel Networks Confidential