Chapter 3: Running the Wizard
Channel Bonding, Clock Correction
The Channel Bonding, Clock Correction screen (page 9) of the Wizard
the channel bonding and clock correction parameters. Also, the common channel bonding
sequence is defined on this page.
X-Ref Target - Figure 3-13
The Channel Bonding settings and sequence definition are common between both
transceivers of each selected pair. The protocol template option for GTP1 (Wizard Page 2)
must be set to Use GTP0 settings to enable the Channel Bonding settings.
Table 3-21, page 37
36
Figure 3-13: Channel Bonding, Clock Correction - Page 9
describes the common Channel Bonding settings.
www.xilinx.com
(Figure
Spartan-6 FPGA GTP Transceiver Wizard v1.8
UG546 (v1.8) December 14, 2010
3-13) defines