Manually Setting The Print Start Position - Roland FLATJET FLJ-300 User Manual

Description
The front edge and the upper edge of the media can be searched automatically. Automatic search is possible on media
up to 95 mm in thickness.
Be sure to set the media at the mark line. If you set it short of the mark line, the media may not be detected.
The print start position cannot be automatically searched on the types of media listed below. For these types of media,
set the print start position using [NUMERAL INPUT].
Media whose thickness is less than or equal to 3 mm.
Media whose front edge or upper edge is not horizontal
Transparent media
Luminous media
Media whose side face contains holes that the sensor passes through.
To set the print start position more accurately, use [NUMERAL INPUT].
A searched position may be off by several millimeters. If this happens, adjust the print start position offset.
p 79 "Adjusting the Print Start Position Offset"

Manually Setting the Print Start Position

Procedure
1.
Set the printer so that manual setting can be performed.
4-2 Setting the Print Start Position
Press [SET UP].
Press [MANUAL SEARCH].
Chapter 4: Feature Reference 59