Printing; Setting The Print-Start Location - Roland VersaEXPRESS RF-640 User Manual

Printing

Setting the Print-Start Location

You can set the print-start location at any location you prefer. (You can print even if you do not set this.) Note,
however, that this setting must be made for each individual page.
Procedure
Press

If you press a cursor key, preparation operation to move the media or the print-head carriage starts. After
the operation finishes, move the media and the print-head carriage to the location where you start the print.
The settings of feed-direction and scan-direction locations determine the print-start
location.
Feed-direction start location
Move the media to adjust the feed
direction.

When the location is set, press

FUNCTION
BASE POINT
W1100mm
B
Note, however, that the left and right positions are not restored to their defaults for test patterns.
If you're using the separately available media take-up system, never adjust by pressing
Doing so may pull the media with undue force, resulting in an error or malfunction.
to move the media and the print-head carriage.
Printing area
Scan (horizontal) direction start location
Scan-direction start location
The base point mark on the right side of the print-
head carriage indicates scan-direction start location.
Feed (vertical) direction
start location
Knife guide
.
When the screen on the left appears, press
the setting.
remains steadily lighted and when the screen displays the char-
acter "B" together with the print-possible width at the location, setting is
completed.
Feed (vertical) direction
start location
Print-start location
Base point
mark
Scan (horizontal) di-
rection start location
2
to enable
.
39