Table of Contents
Advertisement
2-4 Starting to Print
Test Printing and Cleaning
We recommend that you perform a test print to check for problems such as dot drop-outs before you carry out the
actual printing. If problems such as dot drop-outs are found, clean the print heads.
How to Perform a Test Print
Dot drop-out
How to Change the Test Print Position
How to Perform Cleaning
Hold down for at least 1 second
32
Chapter 2: Operation
Hold down
A test pattern is printed.
Test print
The front cover may be open during movement, but be sure to close
it before you press
tion on the Base Control Panel," p 68 "Fine-Adjusting the Print Start Position on the
Printer Control Panel"
Close the front cover and hold down
second to clean the heads. When the operation ends, the initial
screen appears.
Perform a test print one more time to check that dot drop-outs have
been corrected. If the problem persists, clean the heads again. If
the problem is not corrected even after cleaning the heads two or
three times, try cleaning using a different method.
for at least 1 second.
.
p 58 "Setting the Print Start Position," p 67 "Fine-Adjusting the Print Start Posi-
p 41 "When Head Cleaning Is Not Effective"
for at least one
Advertisement
Table of Contents
