Troubleshooting & Diagnostics Section - Bay-Tek Deep Freeze Owner's Manual

Table of Contents

Advertisement

TROUBLESHOOTING & DIAGNOSTICS SECTION
Problem
No power to the
game.
No Audio
Game Lighting not
functioning properly.
Ice Float (playfield)
does not vibrate in
lowered position.
Game doesn't score
or error code is
displayed on Ticket
Display board.
Deep Freeze
Troubleshooting Chart
Probable Cause
a. Unplugged.
b. Blown Fuse.
c. Circuit breaker tripped.
d. Power supply unplugged.
e. Bad power supply.
a. Volume too low.
b. Loose wire.
c. Main circuit board
malfunction.
a. Lamp out.
b. Fixture unplugged.
c. Cable problem.
d. Main circuit board
malfunction.
a. Faulty Kicker Solenoid.
b. Fuse Blown.
a. Loose or broken wiring to
the coin sensor in target.
b. Faulty circuit board,
diodes or sensors.
c. Coin not tripping switch
in coin mechanism.
Remedy
a. Plug game into wall outlet.
b. Check transformer fuse (220v applications
only - 7 amp fast burn).
c. Reset power strip breaker switch or building
circuit breaker. Attempt to determine cause.
d. Insure power supply unit is plugged into
power strip.
e. See power supply diagnostic. Replace if
faulty.
a. Increase the volume at the volume control
at the inside of the front door panel.
a. Check audio cable connections to speaker,
volume control and main circuit board.
Check continuity.
b. Replace main board with board from
another Gen 5 game if possible to isolate
the problem to the main circuit board.
a. Replace burned florescent tubes.
b. Plug power cable into power strip.
c. Check for proper connection to main board.
Check continuity. Replace faulty cable.
d. Replace main board with a spare Gen 5
board if possible to isolate the problem to
the main circuit board. See Service and
Repair on page 19.
a. Replace Solenoid. See page 17.
b. Replace fuse in fuse block. See Figure 4
a. Check for loose or broken wiring at
connectors. Check continuity.
b. Error code indicates faulty target sensor
circuit board. See chart below for
identification of faulty target. For
replacement see page 17.
c. Check operation of the coin mechanism and
switch. Replace if necessary.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents