Kicker Solenoid Replacement; Circuit Boards; Display Circuit Board - Bay-Tek Deep Freeze Owner's Manual

10. Install the new motor onto the motor bracket
and reattach the arm assembly.
11. Reinstall the motor assembly in the game.
12. Fasten the green ground wire and reattach
the sensor connector. Reconnect the motor
power cord to the fuse block and secure all
wires to the game cabinet with wire clips.
13. Test to insure proper operation of the game.

Kicker Solenoid Replacement

The kicker solenoid's purpose is to vibrate the
playfield, when the playfield is lowered, to
remove any loose coins/tokens from the
playfield.
1. Open the rear access door and shut OFF
power to the game.
2. Open the front access door and disconnect
the power cord which is plugged into the fuse
block, . Remove wire clips holding cord
Figure 4
in place.
3. Remove the four hex nuts and star washers
securing the solenoid to the bracket. See
.
12
4. Install the new solenoid in reverse order and
test the game to insure it is working properly.
Be sure the green ground wire is fastened
under a mounting bolt.
FOUR
MOUNTING
BOLTS
Figure 12 Kicker Solenoid
Deep Freeze

Circuit Boards

prior to removing or servicing electronic
equipment in this game. Avoid working on
carpeted surfaces.

Display Circuit Board

The 'Tickets Owed' display circuit board is
replaced as follows.
1. Open the rear door panel and shut off
power to the game by turning the power strip
OFF.
2. Unplug the white phone cord from the circuit
board. See Figure 13.
3. Remove the four hex nuts securing the
board to the upper display and remove the
board.
Figure
4. Install a new board in the reverse manner.
Test the game to insure it is working properly.
Figure 13 Ticket Display Board
CAUTION: Static electricity
could harm circuit boards
and processor chips. Always
ground yourself by cable or
by touching metal surfaces
17