Antennas - HP EliteOne G5 Maintenance & Service Manual

Antennas

The antennas route from the WLAN module to transceivers at the top of the computer. The transceivers are
secured to the computer with adhesive.
Models are available with either single antennas or dual antennas.
NOTE: WLAN module orientation can vary.
To remove the antennas:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the M.2 solid-state drive from above the right speaker (see
6. Remove the power button board and fingerprint sensor board (see
boards on page
7. Remove the audio board (see
8. Remove the rear I/O cover (see
9. Separate the display from the computer (see
10. Disconnect the antennas from the WLAN module (1).
11. Remove the Phillips screw from the top of the right antenna (2), and then peel the antenna off the frame
(3).
Removing the rear port cover on page
Stands on page 24).
Access panel on page
35).
Audio board on page
Rear I/O cover on page
Preparation for disassembly on page
25).
Power button and fingerprint sensor
58).
47).
Display panel on page 60).
23).
23).
Heat sink on page 41).
Antennas 63