HP EliteOne G5 Maintenance & Service Manual page 83

Table 5-3 Computer Setup—Advanced (for advanced users) (continued)
Option Heading
Clear Secure Boot Keys
Lets you delete any previously loaded custom boot keys. Clearing keys will disable secure boot. Default is
Disabled.
Reset Secure Boot keys to factory defaults
Default is Disabled.
Enable MS UEFI CA key
Disabling this setting alters the Secure Boot key list to further restrict the allowed software
components. Set this option to Disable to support Device Guard.
Ready BIOS for Device Guard Use
Requires BIOS Administrator password to be configured and Secure Boot to be enabled.
System Options Configure storage controller for Intel Optane
Enables the Intel Optane memory module.
Turbo-boost
Default is Enabled.
Hyperthreading
Lets you control processor capability. Default is Enabled.
Multi-processor
Use this option to disable multi-processor support under the operating system. Default is Enabled.
Virtualization Technology (VTx) (Intel only)
Controls the virtualization features of the processor. Changing this setting requires turning the computer
off and then back on. Default is Disabled.
Virtualization Technology for Directed I/O (VTd) (Intel only)
Controls virtualization DMA remapping features of the chipset. Changing this setting requires turning the
computer off and then back on. Default is Disabled.
M.2 SSD1
Lets you disable the M.2 solid-state drive slot. Default is Enabled.
M.2 WLAN/BT
Lets you disable the wireless module slot. Default is Enabled.
M.2 SSD2
Lets you disable the M.2 solid-state drive slot. Default is Enabled.
Allow PCIe/PCI SERR# Interrupt
Allows PCI devices to report PCI/PCIe System Error signals, such as address parity errors, data parity
errors, and critical errors other than parity. Default is Enabled.
Power Button Override
Lets you disable or enable and select the number of seconds you have to hold down the power button for
it to force the system to power off. Default is 4 sec.
USB Type-C Connector System Software Interface (UCSI)
Default is Enabled.
Built-In Device Options Embedded LAN Controller
Computer Setup (F10) Utilities 75