Webcam Module - HP EliteOne G5 Maintenance & Service Manual

Webcam module

The webcam is located at the top of the computer, under a plastic shield. The top heat sink screws also secure
the webcam plastic shield.
To remove the webcam module:
NOTE: Webcam appearance can vary.
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. If a discrete heat sink is installed, remove the VESA mounting bracket/fan assembly (see
bracket/fan assembly on page
6. Remove the heat sink (see
7. To remove the webcam plastic shield, remove the two Torx screws (1), and then remove the webcam
shield from the computer (2).
8. Remove the two Phillips screws (1) that secure the webcam assembly to the computer.
9. Disconnect the webcam cable from the system board (2).
44 Chapter 4 Removal and replacement procedures
Preparation for disassembly on page
Removing the rear port cover on page
Stands on page 24).
Access panel on page
48).
Heat sink on page 41).
23).
25).
23).
VESA mounting