Antennas - HP ProOne 600 G3 Maintenance & Service Manual

Antennas

The antenna cables route from the WLAN module to antennas at the top of the computer. The antennas are
secured to the computer with adhesive.
To remove the antennas:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the system board shield (see
6. Remove the top trim (see
7. Disconnect the antennas from the WLAN module (1).
8. Peel the transceivers off the frame (2).
9. Remove the cables from the clips along the routing path (3).
To install the antenna, reverse the removal procedures.
NOTE: When connecting the antennas cables, be sure to match the numbers on the cable with the same
number printed on the WLAN module.
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
System board (EMI) shield on page
Top trim on page 47).
23).
20).
24).
30).
19).
Antennas 49