Heat Sink - HP EliteOne G5 Maintenance & Service Manual

Heat sink

IMPORTANT:
models with discrete graphics includes two extra screws.
To remove the heat sink:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. If a discrete heat sink is installed, remove the VESA mounting bracket/fan assembly (see
bracket/fan assembly on page
6. In the order indicated on the heat sink, loosen the captive Torx screws (1) from the heat sink component
that services the main processor.
IMPORTANT:
downward forces on the processor. This is especially important as the pins on the socket are very fragile,
and any damage to them could require replacing the system board.
7. (Models with discrete graphics only) Remove the non-captive Torx screws (2) from the heat sink
component that services the graphics processor.
8. Remove the non-captive Torx screws from the brackets at the top of the heat sink (3).
HP offers models with either integrated UMA graphics or discrete graphics. The heat sink on
Removing the rear port cover on page
Stands on page
Access panel on page
48).
Remove heat sink retaining screws in diagonally opposite pairs (as in an X) to even the
Preparation for disassembly on page
24).
25).
23).
23).
VESA mounting
Heat sink 41