RF asset module antennas (select products only)
To remove the RF asset module antennas:
1.
Prepare the computer for disassembly (see
2.
Remove the rear port cover (see
3.
Remove the stand (see
4.
Remove the access panel (see
5.
Disconnect the antenna cables from the RF asset module (1), remove the cables from the routing and
clips along the bottom of the chassis (2), and then peel the antennas from the computer (3).
To install the RF asset module antennas, reverse the removal procedures.
38
Chapter 4 Removal and replacement procedures
Preparation for disassembly on page
Removing the rear port cover on page
Stands on page
24).
Access panel on page
23).
25).
23).