Important Advice For The Non-Stick Coating; Technical Specifications - Gastroback Design Crepe Maker Pro Operating Instructions Manual

damage caused by overheating. Do not place any cloth or tissue beneath or on
the appliance, to avoid any risk of fire, electric shock and overheating. Always
keep the table or counter clean and dry and immediately wipe off spilled liquids.
Do not place the appliance near the edge of the table or counter or on inclined
or wet surfaces or where it can fall.
• Do not place the appliance or any parts of it on or near hot surfaces (heater, gas
burner, grill or oven). Do not place the appliance on the power cord. If the power
cord warms up during operation or is likely to be damaged, it must be replaced
by an authorised service centre. Do not attempt to repair the power cord!

IMPORTANT ADVICE FOR THE NON-STICK COATING

The heating surface has a non-stick coating. If the coating is damaged, grazed or
parts of it detach from the heating surface do not use the appliance anymore.
• Do not use any cooking cutlery made of metal or similar hard material on the
heating surface to avoid damaging the coating. Only use cooking cutlery made
of wood or heat insensitive plastic. Never cut on or try to scrape off batter from
the heating surface using hard, sharp-edged items.
• Never use abrasive cleaners, cleaning pads or any hard and sharp objects (i.e.
metal scouring pads) for cleaning. Clean the Design Crêpe Maker Pro with a
damped sponge or tissue and carefully dry the exterior of the appliance after clea-
ning. Do not handle the appliance or any part of it with violence. Never place the
appliance in an automatic dishwasher.
• Never use non-stick spray as this may damages the non-stick coating of the appli-
ance.

TECHNICAL SPECIFICATIONS

Model:
Power supply:
Maximum power consumption:
Length of power cord:
Weight:
Dimensions:
Certification:
Art.-N. 44005 Design Crêpe Maker Pro
230-240 V AC, 50 - 60 Hz
1.250 W
approx. 115 cm
approx. 2.8 kg
approx. 330 x 115 mm (Ø x height)
33