Advertisement
Pre-deployment Checklist and Tasks
Contents
Cisco Expressway-E specific installation tasks
Configure static NAT
1.
Expressway-E sits in the DMZ network and is NATed to a publically routable IP. Once NAT is configured on
the Expressway-E, all communication to and from Expressway-E will use the NATed IP.
Expressway-E points to a public DNS server on the Internet.
Procedure 1
Configure static NAT
The advanced networking key is needed to enable NAT functionality on Expressway-E.
Step 4.
Navigate to System > IP and enter the following into the relevant fields. Leave the other
fields at their default values.
Use Dual Network
IPv4 static NAT
IPv4 static NAT address*—
Step 5.
Click Save.
Deploy MRA and B2B Collaboration
Interfaces—No
mode—On
10.126.69.37
Deployment Details
Deploy CUBE
PAGE 25
Advertisement
