Advertisement
Pre-deployment Checklist and Tasks
Contents
Step 5.
In the message window click OK
Step 6.
On the Trunk Configuration page, click Reset
Step 7.
On Device Reset page, click Reset and then click close
Procedure 4
Enabling the CUBE application on the branch IOS router
Reader Tip
In branch router where CUBE is enabled, recommendation is to have a dedicated MPLS circuit to the
local service provider. Hence, in which case IP addressing scheme might change if we choose to
connect to a different service provider. So it might be required to use a second interface on branch
router to establish the IP PSTN link.
Step 1.
telnet/ssh into the branch IOS gateway
Step 2.
Enter into the global configuration mode to enable the CUBE application
Step 3.
Enable address hiding on the CUBE
Step 4.
Configure the IOS dial-peers on the branch CUBE
Deploy MRA and B2B Collaboration
Deployment Details
Deploy CUBE
PAGE 60
Advertisement
