Pre-deployment Checklist and Tasks
Contents
Procedure 2
Configure the VM guest
Step 1.
Right-click the VM guest and click Open Console. The VM guest will take some time to
boot.
Step 2.
At the login prompt, enter the username admin, and the password TANDBERG.
Step 3.
At the Install Wizard prompt, type y, and then press Enter.
Step 4.
Using the Install Wizard, enter the information
Run install wizard-
Do you wish to change the system
Password-
IP Protocol-
IP Address LAN1-
Subnet Mask LAN1-
Default Gateway
Ethernet
Run ssh daemon-
Step 5.
Next login as a root user and change the default root password. The default root password
is TANDBERG
The configuration is applied and the Expressway-C/E restarts with the new configuration applied. The
system is now ready to be accessed via the web interface for further management and monitoring.
Obtain Licenses
Procedure 3
Step 1.
You will need to access Expressway-C and E in turn via a web browser to identify and
record the Serial Number
Step 2.
Using the serial numbers and the license PAK provided, obtain your licenses via the
licensing portal (www.cisco.com/go/license). This will provide your Release and Option
keys for the next Procedure.
y
[Password]
IPv4
10.106.170.148
255.255.255.128
Address-10.106.170.6
Speed-auto
y
Deploy MRA and B2B Collaboration
password-y
Deployment Details
Deploy CUBE
PAGE 22
Need help?
Do you have a question about the BE6000 and is the answer not in the manual?