Modules Needle-Presser Module; Shaft Attachment - Baby Lock BLMY Service Manual

Modules
5

Shaft attachment

1. Attach the shaft 1.
6
Thread release lever assy. attachment
1. Apply a small amount of MOLYKOTE EM30L to the thread release lever
assy hole 1 in the upper unit holder.
2. Attach the thread release lever assy 2 and polyester slider to the upper
unit holder, and attach retaining ring E3.
*Key point
• The side of the thread release lever assy 2 with the hole 3 is
the bottom.
• Align the pin on the thread release lever assy 2 with the cam
groove 4 in the T cam.
Apply MOLYKOTE EM30L to the thread release
attachment hole
Apply MOLYKOTE EM30L to thread release
assembly shaft
3 - 44
Needle-presser module
Small amount
XC8385***
Small amount
Retaining ring E3
XC8385***
1
4
1
2
3