Main unit
15
Face plate assembly
1. Attach the needle thread lever shaft 1, needle thread lever 2, and rubber
washer 3 to the face plate.
2. Attach the shaft presser plate 4 to the face plate with the screw 1.
3. Attach the screw 2 and the washer 5.
4. Attach the spring
S01
plate 4.
5. Attach the NT lower thread cutter 6 to the face plate, and then attach the
face plate cutter holder with the screw 3.
6. Attach the needle thread lever knob 8.
1
3
2
S01
16
Face plate assy. attachment
1. Secure the face plate assy 1 to the arm bed with the screw 1.
*Key point
• Align and attach the hole in the center on the inside of the face plate
assy 1 to the shaft on the needle-presser module.
1
17
Top cover attachment
1. Attach the top cover 1 to the front cover.
*Key point
• The attachments (two, left and right) for the top cover 1 fall to
the inside.
Main parts
to the needle thread lever 2 and the shaft presser
Taptite, Pan B
M3X6
Taptite, Bind B
M3X10
23
THREAD THROUGH LEVER SPRING
4
Screw, Pan (S/P washer)
M4X14
S01
1
Torque
0.29 – 0.34 N·m
Torque
0.29 – 0.34 N·m
138260***
Torque
0.78 – 1.18 N·m
3
4
1
2
5
2
3
6
7
8
1
1
1
3 - 39