Release Lever Attachment - Baby Lock BLMY Service Manual

Modules
26

Release lever attachment

1. Attach retaining washer E2 to the release lever shaft.
2. Attach the release adjuster 1 to the release lever 2, and hand start screws
1 (two). (Fully tighten following 4 - 25 "Release adjustment.")
3. Attach the release lever shaft 3, polyester slider and release lever 2 using
screw 2.
4. Attach .
S40
1
2
S40
27
Lock nut attachment
1. Attach the screw 1 to the lock nut 1.
*Key point
• The screw 1 in approximately half its length.
2. Install the screw 1 in the upper unit holder.
*Key point
• Tighten until the lock nut 1 hits the upper unit holder.
3. Tighten the lock nut 1.
1
Needle-presser module
Screw, Pan (T washer)
M3X6
Color; Silver
Screw, Pan (S/P washer)
M3X6F
0.79 – 1.18 N·m
Color; Silver
3.6 RELEASE LEVER SPRING
2.9
Set Screw, Socket (CP)
M4X12
0.39 – 0.49 N·m
Torque
Hand tighten
Torque
XC3448***
Torque
1 2
1
S40
2
2 3
1 1
1 1
3 - 55