WING FLAP.
REMOVAL OF WING FLAP. (Refer to Figure 57-2.)
1. Extend the flaps to their fullest degree and remove the bolt and bushing from the rod end bearing by use of
an angle or offset screwdriver.
2. Remove the nuts, washers, bushing, and hinge bolts that hold the flap to the wing assembly.
3. Pull the nap straight back off the wing.
INSTALLATION OF WING FLAP. (Refer to Figure 57-2.)
1. Replace the wing flap by placing the flap into its proper position and inserting the hinge bolts, bushings,
washers and nuts.
2. With the flap control in the full flap position, place the bushing on the outboard side of the rod end bearing
and insert and tighten the bolt.
3. Operate the flap several times to be certain it operates freely.
PIPER AIRCRAFT
PA - 4 4 - 1 8 0 / 1 8 0 T
AIRPLANE MAINTENANCE MANUAL
— END —
3C21
5 7 - 5 2 - 0 2
Page 57-10
Revised: May 15, 1989