Flap Controls And Rigging - Piper PA-44-180 SEMINOLE Maintenance Manual

H. Remove the cotter pin cable guard from the flap cable pulley located inside the floor tunnel just
ahead of the spar housing.
I. Remove the cable rub blocks located in the floor opening on the aft side of the spar housing by
removing the attachment screws.
J. Disconnect the cable turnbuckle at the flap handle by removing cotter pin, nut and bolt.
3 . Remove the flap handle and bracket by disconnecting the cable turnbuckle from the handle and
r e m o ving the bolts securing the bracket to the floor tunnel.
1. BRACKET, ROD ATTACHMENT
2. BOLT, WASHER & NUT
3. JAM NUT
4. ROD, FLAP CONTROL
5. BOLT, BEARING BLOCK ATTACHMENT
6. BRACKET, BEARING BLOCK
7. BLOCK, BEARING
8. NUT, LOCK
9. SCREW, FLAP ADJUSTMENT
10. BOLT, WASHER & NUT
11. CRANK (ARM), TORQUE TUBE
12. BOLT, WASHER & BUSHING
13. FITTING, TORQUE TUBE STOP
14. TUBE, TORQUE
15. BOLT, WASHER & NUT
16. BLOCK, BEARING
PIPER AIRCRAFT
PA - 4 4 - 1 8 0 / 1 8 0 T
AIRPLANE MAINTENANCE MANUAL
FLAP TRAVELS
A = 10° ± 2°
B = 0° ± 1°
C = 25° ± 2°
D = 40° ± 2°
17. SPROCKET, TENSION SPRING
18. BOLT, WASHER & NUT
19. BRACKET, BEARING BLOCK
20. CHAIN, TENSION SPRING
21. CLEVIS BOLT, BUSHING NUT & COTTER PIN
22. SPRING, TENSION
23. CABLE, FLAP CONTROL
24. PULLEY
25. TURNBUCKLE
26. CLEVIS BOLT, NUT & COTTER PIN
27. BOLT, BUSHING, WASHER & NUT
28. BRACKET, FLAP HANDLE
29. FLAP HANDLE
30. CHAIN, RETURN SPRING
31. BLACK, BEARING
32. SPRING, RETURN
33. BUTTON, FLAP RELEASE
Figure 27-25. Flap Controls and Rigging
1L20
27-50-01
Page 27-42
Revised: June 20, 1995