Door Seal Snubber; Door Snubber Installation Diagram - Piper PA-44-180 SEMINOLE Maintenance Manual

DOOR SEAL SNUBBER.

REMOVAL AND INSTALLATION OF DOOR SEAL SNUBBERS. (Refer to Figure 52-1a.)
1. To remove old seals use a thinner. such as toluol, that won't affect the painted surface, and strip off the old
seal.
2. Install the door seal as follows:
A. If the surface has just been painted, allow to dry for a minimum of 2 hours before installing the seal.
B. Wipe the surface clean with a cleaner solvent, such as DuPont Prepsol 3919S.
Refer to the List of Consumable Materials in Chapter 91 for types of appropriate
neoprene adhesive.
C. Make sure both the seal and surface are 65° to 100°F.
B852
PIPER AIRCRAFT
PA - 4 4 - 1 8 0 / 1 8 0 T
AIRPLANE MAINTENANCE MANUAL
— Note —
B
B
D
D
BUTT JOINT SHOULD OCCUR
AT DOOR DRAIN AREA.
Figure 52-1a. Door Snubber Installation
SNUBBER
ORIENT
SNUBBER FLAT
WITH THIS
SURFACE
STRIKER
ORIENT SNUBBER
FLAT WITH THIS
SURFACE
3A23
PLATE
SECTION B - B
SCUFF
PLATE
SNUBBER
SECTION D - D
Page 52-04
Revised: May 15, 1989
5 2 - 1 5 - 0 1