REMOVAL OF ELECTRICAL SWITCHES.
1. For a particular switch removal, remove the screws on the front of the panel.
2. From behind the panel remove the switch, and disconnect the electrical connections.
Make note of the placement of the electrical leads to facilitate reinstalltion.
INSTALLATION OF ELECTRICAL SWITCHES.
1. Reconnect electrical leads with mounting screws in their proper place.
2. Insert switch into its designated slot on the panel and secure with the screws previously removed.
REMOVAL OF CIRCUIT BREAKERS.
1. Remove knurl nut from circuit breaker face plate, front of instrument panel.
2. From behind instrument panel remove circuit protector from instrument panel.
3. Disconnect electrical connections fastened with screws to the circuit breaker.
Make note of the placement of the electrical leads to facilitate reinstallation.
INSTALLATION OF CIRCUIT BREAKERS.
1. Connect the electrical leads to their proper screw and secure.
2. Insert circuit protector into its proper hole on the instrument panel.
3. Fasten and tighten knurl nut to circuit breaker face plate, front of instrument panel.
PIPER AIRCRAFT
PA - 4 4 - 1 8 0 / 1 8 0 T
AIRPLANE MAINTENANCE MANUAL
— Note —
— Note —
—END—
2L5
3 9 - 4 1 - 0 4
Page 39-09
Revised: May 15, 1989