Emergency Exit Window Removal And Installation - Piper PA-44-180 SEMINOLE Maintenance Manual

2. Carefully remove the window from the frame.
A damaged window should be saved to provide a pattern for shaping the new window.
3. Remove old tape and sealer from window frame and molding.
4. Cut or grind the new window to the same dimensions as the window removed.
5. Apply Norton Tape Division, Troy. New York type II vinyl foam tape series 510 or equivalent, on both sides
of the window around the outer edges.
6. Insert the window in the frame and install the retainer moldings.
7. Secure the molding with attachment screws and tighten until the vinyl foam tape is 25 % compressed by the
retainers.
8. Apply Behr-Manning, Norton sealant number PR307 or equivalent, completely around the outer surface of
the window at all attachment flanges.
9. Remove the excess exposed sealer and tape.
DOOR.
EMERGENCY EXIT WINDOW.
REMOVAL AND INSTALLATION OF EMERGENCY EXIT WINDOW. (Refer to Figure 56-2.)
The PA-44 airplanes are equipped with a single pane window installed in the emergency exit door located on
the left side of the pilot's seat. For removal and installation of the emergency exit refer to Chapter 52 of this
manual.
A damaged window will require the removal of the emergency exit door from The
fuselage. If possible the damaged window should be saved to provide a pattern for
shaping the new window.
PIPER AIRCRAFT
PA - 4 4 - 1 8 0 / 1 8 0 T
AIRPLANE MAINTENANCE MANUAL
— Note —
— Note —
3C2
5 6 - 3 1 - 0 1
Page 56-03
Revised: May 15, 1989