TVS Apache RTR 200 Fi4V with ABS Owner's Manual page 69

MAINTENANCE
FRONT WHEEL REMOVAL AND REASSEMBLY
1. Remove the axle nut (1) along with a washer.
2. Pull out the axle (2) along with a washer and
remove a spacer from both the sides of the wheel.
3. Place a support below the frame to prevent
vehicle from falling and lift the vehicle up.
4. Carefully dislocate the disc from the caliper
assembly and slide the wheel out.
5. Reverse the procedure for reassembling.
1
Warning
Ensure proper seating of disc in the caliper assembly
while reassembling the wheel.
2
REAR WHEEL REMOVAL AND REASSEMBLY
1. Remove the wheel hugger rear.
2. Remove the axle nut (1) and along with the washer
and partially pull out the axle (2).
3. Take out the caliper assembly by dislocating it
from the disc and the swing arm lug.
4. Carefully hang the caliper assembly in the swing
arm itself. Take out the spacer and pull out the axle
fully.
5. Remove the wheel assembly by gently tapping it
along with the disc.
6. During re-assembly, engage the drum sprocket
with the wheel along with the drive chain and then
assemble the wheel into swing arm.
1
2
65