Advertisement
ANTI-LOCK BRAKE SYSTEM
t Keep the wheel in such a way that the toner
ring is facing upwards.
t Always use recommended brake fluid. Use fresh,
clean brake fluid.
t Use only the recommended make, type and size
of tyre (ABS tuned with tyre specified by the TVS
Motor Company).
Don't's
t Do not use non-standard tyres.
t Do not pump the brakes. Apply the brakes
continuously
t Do not ignore any warning lamp on speedometer.
t Do not adjust the wheel speed sensor air gap your
self.
t Do not run the engine and ride or rotate the rear
wheel alone in gear with vehicle on centre stand,
for drive chain lubrication, during water wash etc.,
t Do not attempt to correct the toner ring teeth by
bending manually or by using any other mode.
t Do not use different toner ring.
t Do not insert any metallic parts near wheel speed
sensor.
06
t Do not test the ABS on road!!, but use ABS (it is
already tested).
t Do not use non-genuine spares like pads,
discs, tyres etc.
t Do not try to service HECU or open to separate
parts..
Warning
ABS only helps in improving the vehicle control. It is
always good to remember not to exceed the physical
limits of the vehicle stability. It is rider's responsibility
to ride at a suitable speed, while taking care of
conditions and road surface. ABS will not compensate
for errors in the judgement or improper brake use in
the various situation. ABS never eliminates the danger
of falling while turning.
Hard braking during sharp cornering on slippery
surface may lead to vehicle instability. Under such
circumstances gradual braking is recommended.
Use of non-genuine brake pads, tyres, disc etc. leads
to poor braking performance and unsafe riding
conditions.
Hide quick links:
Advertisement
