Avaya J129 Installing And Administering page 43

System parameter
name
L2Q, L2QVLAN
SIP_CONTROLL
ER_LIST
TLSSRVR and
HTTPSRVR
L2Q
September 2017
TLV name Impact
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the parameters
L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The Application Type is not 1 (Voice) or 2 (Voice Signaling).
• The Unknown Policy Flag (U) is set to 1.
TIA LLDP MED L2Q - set to 2 (off) if T (the Tagged Flag) is set to 0 and to 1 (on)
Network Policy if T is set to 1.
(Voice Signaling)
L2QVLAN - Set to the VLAN ID in the TLV.
L2QAUD - Set to the Layer 2 Priority value in the TLV.
DSCPAUD - Set to the DSCP value in the TLV.
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the parameters
L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The Application Type is not 1 (Voice) or 2 (Voice Signaling).
• The Unknown Policy Flag (U) is set to 1.
Proprietary Call SIP_CONTROLLER_LIST will be set to the IP addresses in this
Server TLV TLV value.
Proprietary File
Server TLV
Proprietary 802.1 Q If TLV = 1, L2Q set to 1 (On).
Framing
If TLV = 2, L2Q set to 2 (Off).
If TLV = 3, L2Q set to 0 (Auto).
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the parameters
L2Q or L2QVLAN.
Installing and Administering Avaya J129 IP Phone
Comments on this document? infodev@avaya.com
Note:
This parameter cannot be used in an environment where
both SIP phones and H.323 phones exist.
Configuration through LLDP
Table continues...
43