NEC DT830 Series User Manual page 254

• To disable Bluetooth
STEP 1: Press the Connect key for several seconds
(More than three seconds when the

Bluetooth
key is turn on)).
STEP 2: The Connect key turns off, and the

Bluetooth
mobile phone, which is connected to

Bluetooth
disconnected.
Note: If the connection process between DT830 Series/
DT430 Series and the mobile phone is performed
during pairing mode, the Bluetooth
be disabled.
Note: When the Connect key has not been pressed for 10
minutes while the Bluetooth
to the terminal, the Bluetooth
automatically turn OFF.

feature
feature is ON (the Connect
feature turns OFF. The
, will be forcibly

feature cannot

adapter is connected

feature will

• Bluetooth
Series/DT430 Series to mobile phone

Bluetooth connection is manually or automat-
ically available between a terminal and a mo-
bile phone whose pairing process has been
completed. From the terminal, a Bluetooth
connection can be established only to the
most recently connected mobile phone.
• Automatic Connection
STEP 1: Be sure to confirm that Bluetooth
connection is ON (the Connect key lamp
lights red).
STEP 2: The most recently connected mobile
phone must be within the range of a
Bluetooth
10 meters).
STEP 3: The Bluetooth
terminal and the mobile phone is
established automatically.
Note: When Bluetooth
and the mobile phone is established during a
conversation,
interrupted due to a switch to the Bluetooth
output. You can return to the conversation after 8
seconds since the voice communication is
disconnected.
246
connection from DT830

connection (approximately

connection between the

connection between the terminal
the voice communication


is
