Removing And Replacing The Flexiblelom - HPE ProLiant DL160 Gen10 Maintenance And Service Manual
Hide thumbs
Also See for ProLiant DL160 Gen10:
- Maintenance and service manual (146 pages) ,
- User manual (134 pages) ,
- Product end-of-life disassembly instructions (13 pages)
Table of Contents
Advertisement
Removing and replacing the FlexibleLOM
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1.
Back up all server data.
2.
If installed, remove the bezel.
3.
Power down the server.
4.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5.
Disconnect all peripheral cables from the server.
6.
Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
7.
Remove the access panel.
8.
If necessary, disconnect any internal cables connected to the system board.
9.
Remove the primary PCI riser cage.
10. Remove the FlexibleLOM.
To replace the component, reverse the removal procedure.
48
Removal and replacement procedures
Advertisement
Table of Contents
