Removing And Replacing The Smart Storage Battery And Holder - HPE ProLiant DL160 Gen10 Maintenance And Service Manual

10. To replace the component, reverse the removal procedure.
11. Properly dispose of the old battery.
For more information about battery replacement or proper disposal, contact an authorized reseller or
an authorized service provider.
Removing and replacing the Smart Storage Battery and
holder
NOTE: After the Smart Storage Battery is installed, it might take up to two hours to charge. Features
requiring backup power are not enabled until the battery is fully charged.
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack.
b. Remove the server from the rack.
5. Remove the access panel.
6. Disconnect the cable and then remove the battery.
66 Removal and replacement procedures