Removing The Primary Pci Riser Blank - HPE ProLiant DL160 Gen10 Maintenance And Service Manual

Removing the primary PCI riser blank

Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all
bays are populated with either a component or a blank.
Procedure
1. Back up all server data.
2. If installed, remove the bezel.
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
• Extend the server from the rack..
• Remove the server from the rack.
6. Remove the access panel.
7. Remove the primary PCI riser blank:
Removal and replacement procedures 31