Removing And Replacing The Hot-Plug Power Supply - HPE ProLiant DL160 Gen10 Maintenance And Service Manual
Hide thumbs
Also See for ProLiant DL160 Gen10:
- Maintenance and service manual (146 pages) ,
- User manual (134 pages) ,
- Product end-of-life disassembly instructions (13 pages)
Table of Contents
Advertisement
To replace the component, reverse the removal procedure.
Removing and replacing the hot-plug power supply
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. If the server is using a single power supply only, remove all power from the server:
a. Back up all server data.
b. Power down the server .
c. Disconnect all peripheral cables from the server.
2. Remove the power supply:
a. Release the power cord from the strain relief strap.
44
Removal and replacement procedures
Advertisement
Table of Contents
