KYMCO Super 8 50 Service Manual page 115

9. DRIVE AND DRIVEN PULLEYS
Install the movable driven face onto the
driven face.
Apply grease to the guide rollers and guide
roller pins and then install them into the holes
of the driven face.
Install the seal collar.
Remove any excessive grease.
＊
Be sure to clean the driven face off any
grease.
Set the driven pulley assembly, driven face
spring and clutch assembly onto the clutch
spring compressor.
＊
Align the flat surface of the driven face
with the flat on the clutch drive plate.
Compress the clutch spring compressor and
install the drive plate nut.
Set the clutch spring compressor in a vise and
tighten the drive plate nut to the specified
torque.
Torque: 5.5kg-m
＊
Be sure to use a clutch spring compressor
to avoid spring damage.
Special
Clutch Spring Compressor
INSTALLATION
Install the clutch/driven pulley onto the drive
shaft.
＊
Keep grease off the drive shaft.
Guide Roller
Driven Face
Lock Nut Wrench
Super 8 50
Guide Roller Pin
Movable Driven Face
Clutch Spring Compressor
9-12