9. DRIVE AND DRIVEN PULLEYS
Press a new needle bearing into the driven
face.
CLUTCH DISASSEMBLY
Remove the circlips and retainer plate to
disassemble the clutch.
*
Keep grease off the clutch linings.
CLUTCH ASSEMBLY
Install the damper rubbers on the drive plate
pins.
Install the clutch weights/shoes and clutch
springs onto the drive plate.
Install the retainer plate and secure with the
circlips.
CLUTCH/DRIVEN PULLEY ASSEMBLY
Clean the driven pulley faces and remove
any grease from them.
Install the oil seal onto the moveable driven
face.
Apply grease to the O-rings and install them
onto the moveable driven face.
9-11
Circlip
Clutch Lining
Circlip
Springs
Drive Plate
Oil Seal
Super 8 50
Retainer Plate
Clutch Weights/Shoes
Retainer Plate
Movable Driven Face