Table of Contents
Advertisement
2-3. Measurement Results
Contents of the Measurement Results Screen
The measurement results screen that appears when measurement ends is explained below.
Blood pressure
1
value
2
Graph
[STRESS MODE]
3
button
[REMEASUREMENT]
4
button
5
Heart Rate
Heart Rate/
6
Pulse Rate
7
baPWV
8
ABI
Synchronization
9
line
10
[END] button
[PRINT REPORT]
11
button
*Select this to perform TBI measurement. The TBI package is required for TBI measurement.
If the TBI package is installed, read the accompanying manual.
Displays the blood pressure values at each site where measurement was
performed. Sites where measurement was not performed are not displayed.
This graph shows the relationship between baPWV and ABI.
Press this to perform stress test.
Press to repeat measurement. Select "Repeat measurement using same
condition", "TBI measurement"*, or "ABI measurement" for the repeat
measurement condition.
Displays the heart rate from the R-R interval obtained from ECG.
Displays the heart rate from the R-R interval obtained from ECG. If "ECG" was
set to "OFF" in the "SELECT MEASUREMENT SENSOR" settings when the
patient's information was entered, displays the pulse rate. (refer to page 34 )
This displays the PWV value calculated from the interval from the start of the
brachial pulse wave to the start of the ankle pulse wave.
Displays the right and left ABI. When blood pressure is measured at both
brachia, the ABI is calculated from the highest brachial pressure value.
This line indicates synchro measurement. If the time phases do not match due
to re-measurement or other reasons, this line is not displayed.
Press to end measurement and return to the initial screen.
Press to print a measurement results report.
53
Advertisement
Table of Contents
