Table of Contents
Advertisement
Starting and Ending Measurement
Note:
In some cases one measurement is required and in some cases two measurements are
required to complete measurement. Two measurements are required in the following cases:
• "Synchro measurement" setting is set to "ON" (refer to page 38).
• "Synchro measurement" setting is set to "OFF"; however, blood pressure was not correctly
measured.
• "ABI Remeasurement" setting is set to "ON" and the measured ABI is lower than the set value
(refer to page 78).
The ECG signal and the PCG signal must be stable before measurement can begin.
1.
Make sure that "ECG: OK" and "PCG: OK" are
displayed.
• R-R interval examination can be performed before
measurement is started.
Refer to "2-4. R-R Interval Examination" (page 65).
2.
Press the [START] button on the device.
Measurement begins.
If a second measurement is required, the delay time
count is displayed. Measurement begins when the count
ends.
2-2. Basic Measurement
51
Advertisement
Table of Contents
