Emerson Daniel 3410 Series Instructions For Use, Maintenance And Installation Manual page 56

Meter repairs
June 2019
Table 3-1: Temperature ranges for transducers, mounts and holders
Transducer type
T-11
T-12
T-21
T-22
T-200
(1)
T-21 transducers use W-01 transformers
(2)
T-22 transducers use W-02 transformers
Important
The process temperature should not exceed the operating temperature of the
transducers.
3.3.1 T-Slot transducer removal with extractor tool
To replace transducers under pressure, refer to Ultrasonic Split Clamp Extractor Tool
Operation Manual (Daniel P/N 3-9000-744).
NOTICE
To access the product datasheet from the Daniel products page (above link), select the
Daniel Gas Ultrasonic Flow Meter link, click the Documentation tab, expand the Data
Sheets - Bulletins - Catalogs tab, then select the Data Sheet.
The Daniel Split Clamp Extractor tool is used with Daniel Model 3414, 4-Path
(SeniorSonic
56
(1)
(2)
™
) meters only.
Maintenance and Troubleshooting manual
Temperature range
-20 °C to +100 °C (-4 °F to 212
°F)
-20 °C to +100 °C (-4 °F to 212
°F)
-20 °C to +100 °C (-4 °F to 212
°F)
-50 °C to +100 °C (-58°F to 212
°F)
50 °C to +125 °C (-58 °F to 257
°F)
P/N 3-9000-769
Mount and holder type
Standard mounts/Holders,
NBR O-ring Inconel mounts/
316L Holders,
NBR O-ring Inconel Mounts/
Inconel Holders/FKM O-ring
Standard mounts/Holders,
NBR O-ring Inconel mounts/
316L Holders,
NBR O-ring Inconel Mounts/
Inconel Holders/FKM O-ring
Standard mounts/Holders,
NBR O-ring Inconel mounts/
316L Holders,
NBR O-ring Inconel Mounts/
Inconel Holders/FKM O-ring
Standard mounts/Holders,
NBR O-ring Inconel mounts/
316L Holders,
NBR O-ring Inconel Mounts/
Inconel Holders/FKM O-ring
Standard Stalk Assemblies,
Inconel Stalk Assemblies
Gas Ultrasonic Flow Meters