section 6
6.15
assembly of torch front end (for production thick plate)
caution
•
Reverse order of disassembly.
•
Apply a very thin coat of silicone grease to O-rings before assembling mating parts. This facilitates
easy future assembly and disassembly for service.
•
Installing the electrode requires only moderate tightening.
over tightened parts will be difficult to disassemble and may dam-
age torch. Do not over tighten parts during reassembly. threaded
parts are designed to work properly when hand tightened, approxi-
mately 40 to 60 inch/pounds.
Torch Body
1. Replace electrode holder in torch body. Hex on the
end of the electrode holder removal tool will engage
in a hex in the holder.
Collet
Collet Body
2. To replace the electrode, assemble collet, collet body
and electrode. Insert electrode assembly into the elec-
trode removal tool and ensure electrode makes con-
tact with bottom of tool hole (electrode will fall into
place).
77
pt-36 plasma torch
Electrode, Tungsten