DIRECTIVE DECLARATION OF CONFORMITY ESAB AB, Welding Equipment, SE--695 81 Laxå, Sweden, gives its unreserved guarantee that weld- ing power source Origo Mig 320 from serial number 626 complies with standard IEC/EN 60974--1, in accordance with the requirements of directive (73/23/EEC) and addendum (93/68/EEC) and with standard IEC/EN 60974--10 in accordance with the requirements of directive (89/336/EEC) and add- endum (93/68/EEC).
Page 4
WARNING! Read and understand the instruction manual before installing or operating. WARNING ARC WELDING AND CUTTING CAN BE INJURIOUS TO YOURSELF AND OTHERS. TAKE PRECAU- TIONS WHEN WELDING. ASK FOR YOUR EMPLOYER’S SAFETY PRACTICES WHICH SHOULD BE BASED ON MANUFACTURERS’ HAZARD DATA. ELECTRIC SHOCK - - Can kill Install and earth the welding unit in accordance with applicable standards.
The machines can be fitted with an instrument that displays current and voltage. It incorporates a hold function and can be calibrated. ESAB’s accessories for the product can be found on page 14. Equipment The power source is supplied with:...
Application class The symbol indicates that the power source is designed for use in areas with increased electrical hazard. INSTALLATION The installation must be executed by a professional. WARNING! This product is intended for industrial use. In a domestic environment this product may cause radio interference.
Assembly of stabilizer Assemble the stabilizer if counter balance is to be installed on machine. The stabilizer is an accessory. Ordering number you can find on page 15. Attention! Utilization of counter balance without stabilizer may cause the machine tipping over. Electrical installation - - 7 - - 320e...
Mains power supply Check that the unit is connected to the correct mains power supply voltage, and that it is protected by the correct fuse size. A protective earth connection must be made, in accordance with regulations. Rating plate with supply connection data Origo Mig 320 3∼...
OPERATION General safety regulations for the handling of the equipment can be found on page 3. Read through before you start using the equipment! WARNING - - TIPPING RISK! There is a risk of tipping while transportation and operation, if the welding machine leans more than 10 .
Need help?
Do you have a question about the Origo Mig 320 and is the answer not in the manual?
Questions and answers