Power Source Connections (Con't.) - ESAB m3 G2 System Manual

section 4
4.1

power source connections (con't.)

Buss Bar / Block
1. Strip back the insulation of the 4/0 (95 mm
2. Insert the 4/0 (95 mm
buss bar / block.
3. Tighten the locking screw(s) down on the cable.
Refer to the following table to determine the number of 4/0 (95 mm
notice
Locking Screw
2
) cable in the buss bar / block hole until copper extends to the edge of the
2
your application.
amperage
Up to 200 amps
amperage
Up to 400 amps
Up to 800 amps
Up to 1000 amps
careful attention while stripping the insulation of the 4/0 (95 mm
cable will make installation in the buss clamp easier. Do not spread
or flare the copper conductors.
Chassis must be connected to the machine ground.
remote arc starter Box
Nomex Insulation
) cable, approximately 38 mm.
required # of 1/0 cables
1
required # of 4/0 cables
1
2
3
note:
40
Connection for Pilot Arc Cable
) conductors required for
2
)
2