ESAB m3 G2 System Manual page 78

section 6
When assembling, place the nozzle inside the high current nozzle retaining cup and thread the
high current nozzle retaining cup/nozzle combination on the torch body. This will help align the
nozzle with the assembly. The high current shield cup can be assembled onto the high current
3. Screw electrode assembly in a clockwise direction to torch body. Electrode will
tighten in the correct position when collet closes. When using the high current
nozzle retaining cup remove o-ring indicated and replace it with o-ring, p/n
488158 as shown.
Torch Body
nozzle retaining cup at any time.
remove this o-ring
Nozzle
note:
78
pt-36 plasma torch
place o-ring, p/n 488158 here
Nozzle Retaining Cup